Skip to main content

Nautix Marine

Mooring Winch Brake Rendering Test Adelaide

Brake Testing At Outer Harbor, Inner Harbor And South Australian Ports

Brake Rendering Testing In Adelaide

Port Adelaide is the main gateway for South Australian trade. Container ships and car carriers berth at Outer Harbor, while bulk carriers, tankers and general cargo ships use the Inner Harbor berths up the Port River. Grain is the biggest export, and harvest brings a steady flow of bulk carriers to Adelaide and the regional ports. Nautix Marine carries out mooring winch brake rendering tests in Adelaide with a calibrated hydraulic jack kit, and issues a certificate for each brake tested.

Why Adelaide berths load your brakes

Outer Harbor is open to Gulf St Vincent. Strong south-westerly winds blow straight across the gulf, and ships with high windage, such as car carriers and container ships, push hard on their lines. In the Inner Harbor, passing traffic in the Port River causes surge at the berth. A brake must hold the ship in normal conditions and render before the line breaks in an overload. Many brakes are set only for holding, without checking the render point. A brake rendering test confirms the brake does both, at the load set in your Mooring System Management Plan.

Ports we cover in South Australia

  • Outer Harbor container, car carrier and grain berths
  • Inner Harbor bulk, tanker and general cargo berths
  • Port Lincoln, Port Pirie and Wallaroo, by arrangement with your agent

Planning an Adelaide attendance

Our team flies in from Perth with the full test kit. Please send us the ETA, berth and the winch maker’s data as early as you can, and we will plan the job with your agent. For the regional ports, we can often combine several ships during grain season to reduce travel costs. On board, we fit the test arm, pump the jack in stages and record the pressure at which the drum starts to turn. If a brake is outside the target range, we adjust and mark the spindle, then test again.

Adelaide brake test FAQs

What is the difference between holding and rendering?

Holding is the load the brake keeps the drum still under. Rendering is the load at which the brake slips to protect the line. The test confirms the render point, usually set at 60% of the line SDMBL as advised by OCIMF.

Can you also inspect the winches?

Yes. We can inspect brake bands, linings, drums and pins at the same time. See our mooring winch inspection services.

Other ports we cover

We also test brakes in Melbourne, Fremantle and Albany.

Book a brake rendering test in Adelaide: request a quote or call +61 8 6144 4716.

Brake rendering test fremantle
Mooring winch brake and drum servicing
Mooring winch inspection on a ship deck