A mooring winch brake should slip before the mooring line breaks. A brake rendering test proves it does. This guide explains what happens on deck, which number to test to and when the test is due. If you need a test at an Australian port, see our mooring winch brake rendering test Australia page.
What the test does
The test is a jacking test. A hydraulic jack pushes against the winch drum while the brake is applied. The technician raises the pressure in steps and watches the gauge. When the drum starts to turn, the brake is rendering. That pressure converts to a load in tonnes.
The brake must hold up to the target. It must then slip once the load goes past it. The test does not measure how strong the brake is. It checks that the brake gives way before the line or the fittings do. RightShip’s guide to render testing explains the same idea.
The number to test to
Most operators set the render point at about 60% of the ship design minimum breaking load (SDMBL). OCIMF MEG4 recommends this figure. Use SDMBL, not the breaking load of the line. A stronger new line does not make the winch, the brake or the deck fittings any stronger.
- Your target comes from the Mooring System Management Plan.
- The winch maker supplies the drum data and the test kit instructions.
- Rendering force falls as rope builds up on the drum, so check the maker’s figures for the outer layers.
What happens on deck
- Check the winch data, the SDMBL and the last test record.
- Inspect the brake band, linings, drum, pins and linkage. Fix serious defects before loading the brake.
- Fit the test arm and the jack to the drum.
- Raise the pressure in steps and record the pressure where the drum starts to turn.
- Compare the result with the target.
- Adjust the brake if it is out of range, then test again.
- Mark the brake spindle and record the setting in the winch brake test log.
When a test is due
- At least once a year.
- After new brake linings, or after the drums are skimmed or re-surfaced.
- After fitting mooring lines of a different diameter or type.
- After a brake renders early, or after a mooring incident.
What goes wrong
- Glazed or oily brake linings.
- Seized linkages and worn pins.
- Spindles set too tight.
- The two sides of a split drum behaving differently.
A test finds these faults before a berth does.
What the certificate should show
A signed statement is not enough. A good record names the winch and the SDMBL. It gives the target render load, the measured render load and the gauge pressure. It lists the serial numbers and calibration dates for the jack and gauge. It carries a competent person’s signature and the date the next test is due.
Some Australian ports ask ships to show these records. Check with your agent before arrival.
Nautix Marine tests brakes at Australian ports and issues the certificate. See brake rendering tests in Fremantle, Kwinana and Bunbury, or request a quote. You can also call +61 8 6144 4716.